delay really >> extends work time of fan 1-20 min after end of work..
So delay really have 3 inputs and 2 outputs.
+24V GND and signal
So it should be simple 3 connections to ruida GND Wind and +24V... but no.
The output of wind/status is GND not +24V signal used by relay.
So now I need put a another really to connect Signal input of time relay with 24V
In final is 3 cables going to relay's there is 6 cables connecting 2 really together and 2 output cables.
11 cables mess that works.
Don't tell me that you can just set delay time in Lightburn for status and wind output.
I try connect ruida controller with time delay relay... and its insane.
Moderator: baker
-
- Posts: 19
- Joined: Thu Jan 18, 2024 4:01 pm
Re: I try connect ruida controller with time delay relay... and its insane.
It sounds like you're experiencing some difficulty connecting a Ruida controller with a time delay relay. While you work through that, consider exploring the Monport laser as an alternative. Monport lasers are renowned for their user-friendliness, top-notch quality, and affordability. You can check out their products https://monportlaser.com/collections/co ... ka374VZjm3 They might offer a smoother experience compared to your current setup and could potentially address any frustrations you're encountering with the time delay relay integration.