Basic knowledge - Acrylic

[Guyinthesandpit]

Good evening. I am new to laser engraving and wanted to reach out to the community here for help on how to engrave/cut acrylic.

I recently purchased a WeCreat Vision which has a 20w laser and have had several challenges when it has come to engraving and cutting acrylic. Sometimes the laser burns right through and other times there is not even a mark made.

Attached a picture of a butterfly I tried to cut out but was unsuccessful.

Any support or guidance would be greatly appreciated.

Thank you

[lucasherranz]

A unique encounter, with an emphasis on safety
Verified Females